Polyaniline-based networks combined with Fe3O4 hollow spheres and carbon balls for excellent electromagnetic wave absorption

Polyaniline (PANI)-based networks combined with Fe₃O₄ hollow spheres and carbon balls (FCP) for improved electromagnetic wave (EMW) absorption were investigated using an easy-to-industrialize solvothermal and physical method. Hollow structure Fe₃O₄ spheres with a lower density than that of the common solid sphere were prepared. As a thin and light magnetic material, Fe₃O₄ hollow spheres generate magnetic loss, carbon balls and PANI networks generate dielectric loss. The magnetic and conductive parts play appropriate roles in achieving complementarity in the EMW absorption. The relatively high specific surface area introduced by PANI networks promotes interfacial polarization and further supports dielectric loss. In conclusion, the above reasons provide multiple attenuation mechanisms. Samples FCP1 (?65.109 dB, at 12.800 GHz, 1.966 mm, from 5.6 to 18.0 GHz) and FCP2 (?61.033 dB, at 8.480 GHz, 3.328 mm, from 4.3 to 18.0 GHz) demonstrated a wide bandwidth, a small thickness, a minimum reflection loss (R_L), and a low loading ratio (25%) in paraffin-based composites. Specifically, their loading ration of 25% is much lower than the loading ratio of conventional materials (usually 50% and above). In addition, the bandwidth is excessively wide, above 12 GHz, possessing good absorption performance in continuous intervals with different thicknesses. Such excellent characteristics have rarely been reported in literature.     

瞬态闭锁试验在0.13 μm大规模集成电路中引起的潜在损伤

瞬态剂量率辐射试验会引起集成电路发生损伤或失效，其原因至少有两种：闭锁大电流引起的电路内部金属互连熔融；累积电离总剂量引起的氧化层电荷造成阈值电压偏移。本文以一种0.13 μm体硅CMOS处理器为对象，研究了瞬态剂量率和稳态电离总剂量辐射效应规律。结果表明：瞬态剂量率闭锁效应对处理器造成了显著的潜在损伤，导致其总剂量失效阈值从1 030 Gy(Si)降低至600 Gy(Si)。研究结论对于大规模集成电路的可靠性评估和指导辐射加固设计有重要参考意义。     

钻井机器人的连续油管钻压和钻速控制模型

连续油管钻井机器人利用机身内外的钻井液压力差作为动力源，可在牵引连续油管的同时加载钻压。以钻井机器人为基础，建立连续油管钻柱动力学模型，并推导出通过钻井液排量控制钻压和钻速的单参数控制数学模型；对钻井机器人引入调速回路，建立具有调速功能的钻柱动力学模型；在溢流阀调定压力大于机身内外压差时，推导出利用钻井液排量和节流阀流通面积两种参数控制钻压、钻速的数学模型，在溢流阀调定压力小于机身内外压差时，推导出利用钻井液排量、节流阀流通面积和溢流阀调定压力3种参数控制钻压、钻速的数学模型；以11.43 cm（4.5英寸）井眼为例，对上述3种数学模型进行了分析。分析结果表明：钻压、钻速随钻井液排量的增加基本呈线性增加，在钻井液排量大于0.005 m³/s时，钻井机器人能够向前爬行，在钻井液排量大于0.005 7 m³/s时，钻头能够正常钻进；调节节流阀流通面积和溢流阀调定压力，可以在一定范围内无级调钻压和钻速；3种控制方法相结合，可以实现小排量、大钻压，及大排量、小钻压等钻井参数的控制。以控制模型为基础，针对不同井下工况建立钻进工艺的专家数据库，以钻井机器人为"大脑"，结合井下随钻测量数据就能够实现闭环控制，自动钻进。     

Maximum Data Generation Rate Routing Protocol Based on Data Flow Controlling Technology for Rechargeable Wireless Sensor Networks

For rechargeable wireless sensor networks, limited energy storage capacity, dynamic energy supply, low and dynamic duty cycles cause that it is unpractical to maintain a fixed routing path for packets delivery permanently from a source to destination in a distributed scenario. Therefore, before data delivery, a sensor has to update its waking schedule continuously and share them to its neighbors, which lead to high energy expenditure for reestablishing path links frequently and low efficiency of energy utilization for collecting packets. In this work, we propose the maximum data generation rate routing protocol based on data flow controlling technology. For a sensor, it does not share its waking schedule to its neighbors and cache any waking schedules of other sensors. Hence, the energy consumption for time synchronization, location information and waking schedule shared will be reduced significantly. The saving energy can be used for improving data collection rate. Simulation shows our scheme is efficient to improve packets generation rate in rechargeable wireless sensor networks.     

配加蒙古精矿对球团矿性能的影响

对蒙古精矿在包钢624 m2带式球团的合理利用进行了全面研究。研究表明，随着蒙古精矿配比增加，球团矿品位提高，还原膨胀率增加，当配比小于20%时，还原膨胀率小于20.0%，主要是由于还原后球团矿矿物组成中析出大量金属铁，在浮氏体(FexO)转变为铁的阶段，铁晶粒自浮士体表面向外长出晶须，晶须的生长让晶粒产生位移或晶粒开裂，导致球团结构疏松发生膨胀。通过添加适量矽石，可显著降低球团还原膨胀率，当配加30%～50%的蒙古精矿时，可通过添加1.0%～2.0%的矽石，将球团还原膨胀率降低至20%以内，球团矿质量满足高炉冶炼生产要求。     

硫酸体系中锰钽铌矿加压浸出研究

针对单一硫酸体系锰钽铌矿加压浸出下钽铌浸出率均不到10%的问题,在硫酸体系引入助浸剂,考察氟化铵、双氧水、反应压强、硫酸浓度、反应温度、氟化铵矿比对锰钽铌矿加压浸出的影响,采用XRD对浸渣进行物相表征。实验结果表明,在锰钽铌矿加压浸出中,引入助浸剂氟化铵,温度200℃、硫酸浓度50%及氟化铵/矿比为0.8∶1的条件下钽浸出率超过93%,铌浸出率超过96%。引入氟化铵对硫酸体系下锰钽铌矿的加压浸出效果的提升十分显著。     

临床腋窝淋巴结阳性老年三阴性乳腺癌局部治疗策略

因老年乳腺癌患者多伴发基础疾病,在选择局部治疗方案时,除应考虑原发肿瘤本身因素外,还需评估患者重要器官功能及其对治疗的耐受能力。三阴性乳腺癌与其他亚型乳腺癌相比,主要表现为侵袭性强、预后不佳;而临床腋窝淋巴结阳性的老年三阴性乳腺癌患者,局部治疗的选择则更为棘手,对于此类特殊群体,尚需探索更为合理的个体化治疗方案。     

Corrosion behavior of under‐, peak‐, and over‐aged 6063 alloy: A comparative study

The mechanical property of age‐hardenable Al‐alloys is governed by the state of ageing, which determines the microstructure and consequently, their corrosion behavior which is a vital aspect for a number of applications. This article presents a comparative assessment of corrosion behavior of under‐, peak‐ and over‐aged Al‐Mg‐Si alloy. Corrosion characteristics have been determined via immersion tests in 0.1 M ortho‐phosphoric acid solution and intergranular corrosion (IGC) tests. Corroded surfaces are examined by field emission scanning electron micrographs‐energy dispersive spectroscopy and 3D optical profilometer. The obtained results reveal that the corrosion rate at a specific immersion time as well as the depth of IGC increases in the order for under‐, peak‐, and over‐aged states. Irrespective of the state of ageing, corrosion loss increases linearly but the rate of corrosion decreases rapidly with increasing immersion time. The dominant mode of corrosion in under‐aged alloy is identified as localized pitting, while peak‐aged is highly susceptible to IGC in contrast extensive pitting corrosion is observed for over‐aged alloy. The observed differences in corrosion behavior are explained considering characteristics of precipitates. Formation of β (Mg₂Si) in case of over‐aged alloy and presence of inclusions like AlFeMnSi particles are found to accelerate pitting corrosion.     

提高加盖钢包自开率的研究与实践

首钢京唐300t钢包加盖后自开率明显下降，分析了加盖钢包自开率下降的机理，确定了主要原因是包衬温度升高后造成的液态渣回流。通过对引流砂的流动性、密度和渗钢性研究，设计了一种适用于加盖钢包的引流砂成分配比，并通过控制Al2O3和MgO含量，保证铬矿砂纯度。改进了钢包热修工艺，设计了针对加盖钢包的投砂操作和防钢渣回流措施。研究结果经推广使用后，钢包月不自开炉数由8～9炉降低至2炉以内，综合自开率达99.9%，双精炼工艺自开率达100%。     

负径向电场对带电粒子俘获率影响的数值模拟

本文采用数值方法求解Grad-Shafranov方程反演EAST典型长脉冲放电实验(炮号33068)的平衡位形和磁场分布，进而结合粒子在托卡马克电磁场中的运动方程，模拟氘离子在负径向电场存在时的运动轨迹，并统计不同负径向电场下的氘离子俘获率。结果表明：随负径向电场的增大，氘离子轨迹由扩张通行轨迹向外翻香蕉轨迹再向内翻香蕉轨迹，最后向压缩通行轨迹演变；氘离子俘获率随负径向电场的增大而减小，氘离子初始速度越小，其变化越大。